What should we do if the workshop does not have air conditioners and is not ready to install them

Thermostat or oven can be considered according to experience. The substrate should also be warmed or baked. Some glues (such as some silica gel, polyurethane, two-component epoxy adhesive, etc.) can be preheated, while solvent adhesive and some acrylic acids containing low flash point substances (including anaerobic adhesive, AB adhesive, UV adhesive) should preferably be warmed by air conditioning. Glue shall be applied after the glue and base material are warmed up or preheated by baking. However, if the temperature is too high, the glue operation time may be shortened. This should be noted. After the glue is applied, it shall be properly insulated or baked until the glue is solidified. When using ovens and thermostats, be sure to observe and do a good job in fire and explosion prevention