Can HANAST adhesive potting adhesive be applied to circuit boards?

Can HANAST potting adhesive be applied to circuit boards? Some customers want to apply a layer of waterproof adhesive on the circuit board to achieve waterproof effect. They asked me if it is difficult to apply sealing adhesive, but it cannot be applied on top to achieve waterproof effect. Because the three proof paint is mainly used to prevent moisture and cannot achieve waterproof effect at all. However, although sealing adhesive can achieve waterproof effect, it must be sealed when used.

The sealing adhesive of HANAST adhesive is mainly used in electronic components and bathroom. Waterproof, moisture-proof, and gas pollution resistant coatings for backlights, solar energy, connectors, electrical modules, transformers, sensors, and LEDs, as well as sealing adhesive protection.
HANAST adhesive potting adhesive is a two component liquid packaging. After the liquid is fully mixed, it is injected into the shell of the electronic mechanism. After curing, the elastic body will not shrink or release heat, and can isolate water vapor, dust, and straw buffering. In addition, it is also an ideal material for insulation and thermal conductivity.

The HANAST adhesive engineer has informed you that it is not recommended to apply potting adhesive and can only be used for potting. Its viscosity is relatively low and its fluidity is high, making it impossible for it to stay on the circuit board during application. There is actually a certain difference between three proofing paint and potting adhesive.