The special glue for electronic components can be used in the potting of circuit boards and components. It will not corrode the circuits of various materials and can play a protective role.

The ratio of the condensation type potting compound is 10:1, which needs to be cured at room temperature; while the compounding ratio of the addition type potting compound is 1:1, which can be cured at room temperature or heated.

Can be deployed into black, white, gray, blue according to needs.

Will the improper distribution of the two-component potting compound affect the quality?

Precautions: After the operation is completed, the unused glue should immediately tighten the cap and keep it sealed. When using it again, if there is a little crust on the seal, just remove it, silicone sealant silicone bond adhesives&sealants glues paste, and it will not affect the normal use. During the storage of the glue, a small amount of solidification may also appear at the mouth of the nozzle, which can be used normally after being removed without affecting the product performance. 

Instructions First clean the components to be glued to remove the oil on the surface, then squeeze out the product from the tube and apply it on the surface of the components. The glue will gradually solidify from the surface to the inside when it contacts the moisture in the air. elastomer. When in use, the adhesive layer must be fully in contact with the air. The larger the contact area, the faster the curing, otherwise it will be slower or even not cured. The thicker the adhesive layer, the longer the vulcanization time, the greater the humidity and the higher the temperature in the same environment, the faster the curing speed of the adhesive layer. The opposite is the opposite. After the product is used, the hose should be tightly capped immediately, and it can be stored for reuse. For automatic production lines, pneumatic glue dispensers can be used to apply glue.

2. Purpose RTV silica gel is used as a bonding, sealing, insulating, moisture-proof and shock-proof material; it is widely used in the bonding and sealing of electronic components, semiconductor materials, electronic appliances and other equipment, electric heaters, waterproofing and sealing of electronic instruments, and potting of electronic components. Etc.; specifically, such as the sealing of electric heating ends, the bonding of small motor magnetic tiles and metal casings, the bonding and sealing of automotive lights, optical instruments and lenses, the bonding of electronic instrument casings, the insulation protection of motors, and the bonding of electronic components. It has good bonding performance, excellent electrical insulation performance of the cured product, moisture-proof and shock-proof function, non-toxic, non-polluting, and non-corrosive; has good electrical insulation and arc resistance, aging resistance, moisture resistance, and good adhesion. Connectivity, suitable for -60 ℃ ~ 250 ℃ working temperature;

Features This product is a neutral one-component room temperature curing liquid silicone. It has excellent resistance to cold and heat changes, stress changes and other properties, high and low temperature resistance, and maintains elasticity and stability for a long time at -50-250 °C. It has the excellent aging resistance and UV resistance that ordinary silicone rubber has; it also has the characteristics of excellent shock resistance, moisture resistance, electrical insulation and arc resistance. The product has a short surface drying time and is suitable for rapid production bonding; it has strong adhesion to most metal and non-metal materials; it is non-toxic and non-corrosive; it is easy to use, safe and pollution-free; it has good storage stability and can last up to 12 moon. The product fully complies with the requirements of EU ROHS directive.

Vacuum exhaust bubble treatment: After the silicone gel and curing agent are evenly mixed, the vacuum exhaust bubble process should be carried out. The vacuum extraction time should not be too long, and under normal circumstances, it should not exceed ten minutes. If the vacuum extraction time is too long, the silicone gel will immediately solidify, causing cross-linking reactions, making the silicone gel into pieces and unable to be painted or poured, which wastes the silicone gel. The silicone gel can only be poured into the trash can and re taken for processing.