This product is a two-component RTV-2 silicone potting adhesive material with low viscosity value and good fluidity. It can seal the product structure gap without dead angle. It can be quickly and deeply vulcanized at room temperature. It is widely used on the surface of PC, PP, ABS, PCB, PVC and other materials and metals. Its adhesion is ≥ 0.3mPa, and its flame resistance can reach 94V0 level; The silicone material has weather resistance and will not crack, fault, embrittlement and other conditions. It can protect the product for a long time. It is suitable for the functions of insulation, waterproof, moisture-proof, dust-proof, anti-buffering and stress reduction of electronic accessories.

As a bonding, sealing, insulating, moisture-proof and shockproof material, RTV silica gel is widely used in the bonding and sealing of electronic components, semiconductor materials, electronic appliances and other equipment, as well as the waterproof and sealing of electric heaters and electronic instruments, and the filling and sealing of electronic components. Such as the sealing of electric heating end, the bonding of small motor magnetic tile and metal shell, the bonding and sealing of automobile lamps, optical instruments and lenses, the bonding of electronic instrument shell, the insulation protection of motor, the bonding and sealing of electronic components, etc.

With the miniaturization and high efficiency of electronic and electrical appliances, the heat dissipation capacity of heat dissipation materials is constantly challenged. The more common is the rapid charging of mobile phone PD, which takes 5 minutes to

The potting adhesive has fluidity during the injection process. After curing, the surface is very smooth and has a smooth film layer. However, some users find that the surface of the potting adhesive is uneven after curing. What is this phenomenon? Can it

Solar energy is a renewable energy widely used in modern times, such as solar power stations, street lamps, water heaters, etc; The photovoltaic junction box is an important connection device between the solar cell array and the solar charging control dev

Heat dissipation silicone grease is a high thermal conductivity insulating silicone material used to fill the gap between CPU and heat sink. As an intermediate medium for heat transfer, it can extend the service life of equipment; As we all know, the high

How about the aging resistance of headlamp sealant? The function of the headlamp sealant is to prevent water from entering the interior of the headlamp and causing damage to the headlamp; However, the performance of anything will gradually deteriorate af

The thermal conductive potting adhesive has strong fluidity and can be automatically reserved in each gap during potting. After curing, the adhesive layer has elasticity, which can isolate water vapor, room temperature and other substances, and also help

The drying temperature shall not be too high. It has no difference from the bonding after natural drying. The drying is mainly to speed up. The effect should be no different, and the key is to prevent pollution. It is reported that the adhesive force of drying is higher than that of non drying. Natural drying will only work on the solvent of the glue solution, while drying will dry away the moisture in the environment. The surface will be drier, with better effect and less blistering. The efficiency is high, and the bonding will be improved when molding while hot. When the mold is naturally dried, it is easy to stick to the mold. Later, it was dried instead of sticking to the mold, and the effect is better. Drying is easier to control the process, so as to ensure the consistency of product quality. There are many uncertainties in natural air drying, which is not very conducive to product quality control.